Ray's Camper Stuff
Page 4
Potable Water tank level Indicator
The next mod I did was to install a Potable water take gauge. I acquired the gauge for RV Electronics in Australia. Way cool gauge.
To install it:
go up on the tank about 3/4 of the way up and drill a 7/8 inch hole in the tank. Insert the sender and tighten the nut.
Next run the wire to where you want to enter the camper and drill a hole to access the area.
Pass the wire thru to the inside.
Connect the wire to the gauge and using the mounting tape, mount it to the wall.
The gauge is self powered with a small 12v battery.
The total time to install was about 1 hour.
There instructions to install are on there site. The gauge works really good so far